|
| Our Laser Optic Alignment tool can be used to align equipment to a degree that was unheard of 10 years ago. We use the "Opt-Align" system with great success. Any direct coupled equipment alignment can be improved on which results in less wear and tear on bearings, seals, bushings, etc. In addition to lowering maintenance costs, proper alignment can lower operating costs by lowering the amount of power it takes to drive your machine. With the Opt-Align laser, the accuracy must be seen to be believed.
Do you have tight tolerances for your direct couple equipment? How about thermal growth? Does the motor grow while the pump torque's clockwise? Our equipment can use your specifications to overcome these problems to the .001 of an inch. |
All of the alignment work done by B.E.I. is done with Stainless Steel Shims. We use LAWTON shims, for which we are a distributor. We chose LAWTON because we believe that they are the best in the industry and our customers expect the best.
 LAWTON shims are cut from 304 stainless stock, which will not rust or deform.
- Uniform thickness from .001 to .120.
- Uniform die cut shapes.
- Unique tab type design allows installation or removal without getting hands or fingers under equipment.
- Each LAWTON shim is permanently marked for size and thickness identification.
- LAWTON shims eliminate the need for shims or shears, which eliminates the sharp edges that cut your employees.
- By using the LAWTON shim kits, you eliminate the need for rolled shim stock and the time consuming task of cutting and re-cutting. There is no wasted materials with pre-cut shims either.
- From individual packets of 25 to the entire shim set, LAWTON provides quality and reliability, time and again.
|
| | |
